Issue with Midi Controller - nanoKONTROL2

[radio42]

Sure, first you can try to stop and restart the MIDI control itself (in the general settings, section GPIO).
But if that doesn’t help, I guess a reboot of the PC is needed.
Have you changed anything in your setup? Eg. Added a USB or MIDI hub? Cable issue…?
Or even changed anything in the MIDI mapping, settings?

[radio42]

Sounds good!
Here is a link with a similar issue: https://www.proppfrexx.radio42.com/foru ... hp?p=13476

[radio42]

Unfortunately not. If the MidiView is working and shows the MIDI Messages - but ProppFrexx (in the monitor) doesn’t show anything - this seems, like there is some configuration issue with the MIDI port.
And as it was working good before, there must be some change in your setup/system… but I also don’t have any idea, what it might be.

Have you maybe changed the ‚Auto Pair…‘ option? This should typically be disabled.

[radio42]

Good to here! So that sounds, like the MIDI controller somehow got stuck…

[radio42]

Probably a pure coincident.

[emmanoah]

Korg nanoKONTROL2 is a compact-sized multi-function mixing control surface connected with your monitor. A single MIDI Out shA single MIDI Out should not be used to connect many synthesisers in a long daisy chain of MIDI cables. While MIDI recording and playback may be possible with this configuration, SysEx transfers are far more demanding on hardware and software. If necessary, utilize a MIDI Thru box so that your connections spread out from one point rather than in a lengthy line. Make sure you have enough MIDI Ins and Outs to maintain a maximum chain length of two or possibly three synths.